Welcome to Prosper Automation

成功自动化Prosper Automation

ProfessionalPCB Electroplate Equipment
Call+86 752 6650688
Products

Current Location:Home > Products > Flexible FPC / VCP Plating Line > FPC soft board VCP plating line

  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
  • FPC soft board VCP plating line
FPC soft board VCP plating line

Transmission system

1. The transmission motor adopts a broadband motor and a frequency converter, and the transmission speed range is relatively wide, which is convenient for customers to have more choices in electroplating production.

2. The tensioning device adopts pulley type and counterweight for tensioning, and the moving frame is equipped with linear bearings.

3. The chain plate type is equipped with steel wheels, and the steel belt type is equipped with steel wheels. Different transmission modes can be selected according to the type of production plate and the cost of use.

Electroplating fixture

1. The clamp adopts double clamping points, and the clamping point is 4-6mm optional.

2. Standard fixtures and anti-plating fixtures, different fixtures can be selected according to the type of production board and the cost of use.

Conductive device

1. The chain plate type is equipped with a high wear resistance conductive carbon brush copper block, a stainless steel conductive wire is installed between the steel plates, a high-density UPE is used for the walking rail, and a red copper flat is used for the conductive circuit rail.

2. The steel belt type is equipped with high wear resistance conductive carbon brush copper block, the walking rail adopts high density UPE, and the conductive circuit rail adopts red copper flat.


Trough

1. Each group of electroplating tanks are equipped with two anode baffles, which can be adjusted.

2. The guide bar is fixed in the groove

Jet system

1. The side spray of the electroplating tank adopts a set of arranged staggered spray design to avoid busy spots of the spray.

2. The spray pump on the side of the electroplating tank uses a frequency converter to adjust the spray flow. The size of the production board and the frequency set by the computer DMS can be adjusted according to the needs of the production board.

Equipment use and maintainability; equipment structure is simple and easy to operate, low failure rate, convenient maintenance, and low operating cost.

Plant requirements: The equipment has good utilization of plant space, small footprint, and more savings in water and electricity consumption.

Production environment: The equipment is fully enclosed and equipped with top exhaust, which has less environmental air pollution and is more environmentally friendly.

Detailed introduction
Related Products
少妇极品熟妇人妻无码,乌克兰18极品xx00喷水,在线观看黄a片免费网站,两根黑人粗大噗嗤噗嗤视频